Chip-based furniture panels
Particle Board
Confirm the board grade, density-related requirement, thickness, surface and intended furniture application before quotation.
- Chip-based panel core
- Raw and melamine-faced supply
- Density-related requirements
- Furniture application details
Raw and melamine-faced supply routes are confirmed against the selected specification.
01
Confirm the board
Grade, density, thickness and intended application.
02
Confirm the surface
Raw panel or melamine décor, texture and faced sides.
03
Confirm the order
Quantity, packing, marks and technical document scope.
Supply options
Raw panels and melamine-faced panels
Start with the substrate construction, then confirm whether the order requires a raw board or a finished decorative surface.
How particle board behaves
Compare the particle structure and component requirements
Particle board uses graded wood particles pressed into a density profile. It is widely used as a cost-efficient furniture substrate, especially with melamine surfaces, but edge fastening, internal bond and moisture exposure need to match the component design.
Panel structure
Review face and core particle distribution, density profile, internal bond expectation and finished thickness rather than comparing density alone.
Furniture processing
Provide drilling positions, connector type, edge-banding route and expected assembly cycles when edge screw holding or cam fittings are important.
Inspection focus
Check thickness, density or sheet weight, surface condition, edge integrity, moisture, swelling requirement and the agreed emissions class.
Where it fits
Commonly selected for flat furniture, cabinet carcasses, office furniture and melamine faced components with controlled machining.
Before substituting
MDF can provide cleaner profiled edges, while plywood may suit higher strength or moisture demands. Compare the finished component, not only the sheet price.
Specification guide
Information to confirm before quotation
These fields organize the first technical discussion. Actual ranges and commercial terms will be added only after the relevant supply route is confirmed.
You can start with:
- Product and application
- Required size or reference
- Approximate quantity
- Destination port
| Board grade | State the application and required particle board option Confirm for quotation |
|---|---|
| Density requirement | Provide a target or approved reference when relevant Confirm for quotation |
| Panel size | Specify length and width Confirm for quotation |
| Thickness and tolerance | State the finished requirement and tolerance Confirm for quotation |
| Surface | Raw particle board or melamine-faced option Confirm for quotation |
| Moisture / emission option | Confirm the required grade and document scope Confirm for quotation |
| Application | Furniture component, interior use or another confirmed application Confirm for quotation |
| MOQ and lead time | Based on grade, surface and order combination Confirm for quotation |
Selection points
Make the requirement measurable
Replace broad terms such as “high quality” with construction details, approved references, named standards and agreed acceptance points.
01
Density profile
Confirm the value or performance requirement relevant to the component.
02
Screw holding needs
Share the intended fixing and component design when it affects selection.
03
Surface and edges
Define acceptable surface condition and edge damage criteria.
04
Moisture option
Match the grade to the actual service condition.
05
Emission requirement
Confirm the named standard and required evidence.
06
Packing and marks
Agree protection, bundle quantity and identification.
Order follow-up
Keep the finished panel tied to the specification
The applicable checks depend on the product, order and documents agreed before production.
01
Record the requirement
Confirm the construction, surface, dimensions, application, packing and document scope.
02
Follow the order
Connect relevant production details and approved changes to the written specification.
03
Review and prepare
Check the agreed finished-panel points before packing and export preparation.
Start with the details you have
Discuss your particle board requirement
A product name, application or reference image is enough to begin. The remaining specification can be confirmed during the enquiry.